ADE Accenta G3 Instruções de Operação descarregar pdf (Página 5)

Wiring the system

Caution: Always power-down the panel

when wiring external circuits, to prevent

damage to the panel electronics.

Systematically wire and test each circuits.:

ÿ

Zone, Tamper circuit and PA circuits

ÿ

Finish by wiring any additional extension

speaker sounders, external bell/sounder,

strobe and the 13V supply.

Tamper network

The Tamper circuit is used to protect all cables

and detectors in the system from unauthorised

access including the panel and RKP covers.

The zone and PA tampers should be series wired

and connected to the TAMP terminals.

TerminalsT&Aarefortheexternal bell /

sounder tamper. The TAMP terminals at the

bottom left of the PCB are for the RKP tampers.

Tamper alarms that occur in the Day mode

operate internal sounders only. Tamper alarms in

Set cause a full alarm condition. Tamper is

indicated on the control panel and RKPs by the

Tamper indicator.

Connect Remote Keypads /

Lighting controllers

Note: Where an Accenta G3 or Accenta

mini G3 panel is being installed ensure

there is at least one remote keypad wired

to the panel before first power up.

A combination of up to four remote keypads and

lighting controller can be connected to the panel.

Security zones

Note: The G3 range of panels are not

supplied with wire links for unused

zones. All unused zones must be

programmed out by setting them to

disabled using the Zone Type function

see page 19.

It is recommended that no more than 10

magnetic contacts are connected to the same

zone.

4PI175 issue 1_6/01 5

Accenta/Optima G3 intruder system Engineering information

Wiring the system

J5

0V

TAMP

+13V

COMMS

SOUND

1A

RKP FUSE

F2

Panel

Board

SOUND

TAMP

COMMS

13V

0V

Keypad

Board

COMMS

12V

SOUND

LD R

Maximum of up to 4 Remote Keypad /

OPTI-CAM Lighting Controller

combination allowed

Board

SOUND

TAMP

COMMS

13V

0V

Keypad

Board

GND

OPTI-CAM Lighting

Controller

(See also the instructions supplied

with the OPTI CAM lighting controller)

If only one Remote keypad

is being used then connect TAMP

back to the

p

anel

J2

2

1

4

3

6

5

8

7

Panel

Alarm

+-

PA

+

-

TAMP

+13V 0V

PIR

Unused zones must

be programmed as

Unused.

Board

PIR

Door

Contact

Door

Contact

Terminal block

is not supplied

Tamp

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comentários a estes Manuais

Sem comentários