ADE Captiv8-20 Instruções de Operação descarregar pdf (Página 7)

Silence Alarm and

Reset system

To silence an Alarm

If an alarm occurs whilst you are in or near to the

premises the alarm can always be silenced by

entering your code or alternatively present

a proximity tag. If the system was set it will be unset

at the same time. If the alarm occurs while you are

away from the premises the outside and inside

sounders will automatically stop after the bell time

programmed by the engineer, see your System

Information for the bell time.

When you enter your code after an alarm, the keypad

will display the cause of the alarm.

The second line shows additional information, such as

the zone which caused the alarm. The system will

now need to be reset as described in the next section.

To reset after an Alarm

After an alarm the system will need to be reset by

entering a code . The display will alternate

between the alarm cause and a prompt to enter a

reset code.

If this prompt is displayed you can reset the system

using your own code. Key in your code .

After the system has been reset it may enter a fault

lockout, see fault lockout see page 8.

To reset by Engineer Code

If the engineer has programmed the system for

engineer reset, check the System information, it may

need to be reset by an engineer code. First, try

entering your code; if the keypad displays:

You may need to call out the engineer to reset the

system. Before you do this, check the System

information to see if either the Remote PC Reset or

Anti-code Reset options have been enabled, if so then

go to the respective section in this booklet to reset the

system.

Once the reason for activation has been determined

the Engineer will reset the system by entering his

code .

After the system has been reset it may enter a fault

lockout, see page 8 .

To reset by Anti Code

If Anti-code reset has been enabled the keypad will

display the 4-digit Quote code.

Make a note of this number nnnn (it is different each

time you use this facility) and telephone your Alarm

Receiving Centre (ARC). You may need to give

details of the alarm and quote a password. You will

also need to quote the 4 digit number nnnn. The

Alarm Receiving Centre will quote a 6 digit number

called an anti-code.

Key in the anti-code to reset the

system. The display will either clear and the system

will revert to unset mode, or it will display the number

of faults which still exist - this is a fault lockout see

page 8.

Captiv8-20

Reset required

Enter Your Code

INTRUDER

BACK DOOR

Engineer Reset

Required

Quote Code nnnn

Enter Anti code

Intelligent Security & Fire Ltd

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comentários a estes Manuais

Sem comentários

ADE Captiv8-20 Instruções de Operação Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso ADE Captiv8-20